HACMP Installation on AIX 6.1

1. Check for required AIX BOS components
2. 
   

# lslpp -l bos.adt.lib # lslpp -l bos.adt.libm # lslpp -l bos.adt.syscalls # lslpp -l bos.net.tcp.client # lslpp -l bos.net.tcp.server # lslpp -l bos.rte.SRC # lslpp -l bos.rte.libc # lslpp -l bos.rte.libcfg # lslpp -l bos.rte.libcur # lslpp -l bos.rte.libpthreads # lslpp -l bos.rte.odm # lslpp -l bos.lvm.rte # lslpp -l bos.clvm.enh

1. If any of the above fileset is missing, install these from the AIX installation media.
2. 
   

# installp -acgXYd . bos.adt.libm # installp -acgXYd . bos.adt.syscalls # installp -acgXYd . bos.clvm.enh # installp -acgXYd . bos.net.nfs.server ( Required for NFS ) # installp -acgXYd . bos.data

1. Run bosboot command to rebuild the boot image.
2. 
   

# bosboot -ad /dev/hdisk0 # bosboot -ad /dev/hdisk1

1. Install RSCT images from HACMP installation images
2. 
   

Install RSCT filesets from HACMP installation image, if it is not installed during AIX installation.

Note: Install the higher version of RSCT if available in AIX installation media.

1. Install HACMP Cluster filesets.
2. 
   Note: Installation may fail of the required version of RSCT is not installed

Go to PowerHa installation binary location.

Install the Cluster filesets either by SMIT or installp.

cluster.adt.es cluster.assist.license cluster.doc.en_US.assist cluster.doc.en_US.es cluster.doc.en_US.glvm cluster.doc.en_US.pprc cluster.es.assist cluster.es.cfs cluster.es.cgpprc cluster.es.client cluster.es.cspoc cluster.es.ercmf cluster.es.nfs cluster.es.plugins cluster.es.pprc cluster.es.spprc cluster.es.server cluster.es.svcpprc cluster.es.worksheets cluster.license cluster.man.en_US.es cluster.msg.en_US.cspoc cluster.xd.glvm cluster.xd.license

1. Reboot the nodes after installation.
2. 
   

# shutdown -Fr

1. Update /etc/hosts files on both the nodes
2. 
   

###### Entries Required for HACMP ##### # Persistant IP 10.112.75.48 wisapp1per 10.112.75.49 wisord1per # Boot IP 10.2.2.77 wisapp1p wisapp1p_bt # Boot IP for wisapp1p 10.2.2.78 wisord1p wisord1p_bt # Boot IP for wisord1p # Standby IP 10.2.3.77 wisapp1p_stby # Standby IP for wisapp1p 10.2.3.78 wisord1p_stby # Standby IP for wisord1p # Service IP 10.112.75.74 wisappsvc

1. Assign the IP address to both the nodes as shown below
2. 
   

wisapp1p en0 10.2.2.77 en1 10.2.3.77 wisapp1p en0 10.2.2.78 en1 10.2.3.78